Hub/Switch Reference Guide

IP Services Commands 163
Nortel WLAN—Security Switch 2300 Series Command Line Reference
See Also
• clear ip telnet on page 102
• set ip https server on page 116
• set ip telnet on page 120
• set ip telnet server on page 120
• show ip telnet on page 155
show ip route
Displays the IP route table.
Syntax show ip route [destination]
Defaults None.
Access All.
Table 8: Output for show ip https
Field Description
HTTPS is enabled/disabled State of the HTTPS server:
• Enabled
• Disabled
HTTPS is set to use port TCP port number on which the WSS listens for HTTPS
connections.
Last 10 connections List of the last 10 devices to establish connections to the WSS’s
HTTPS server.
IP Address IP address of the device that established the connection.
Note: If a browser connects to a WSS from behind a proxy, then
only the proxy IP address is shown. If multiple browsers connect
using the same proxy, the proxy address appears only once in the
output.
Last Connected Time when the device established the HTTPS connection to the
switch.
Time Ago (s) Number of seconds since the device established the HTTPS
connection to the switch.
destination Route destination IP address, in dotted decimal notation.