Hub/Switch Reference Guide
IP Services Commands 153
Nortel WLAN—Security Switch 2300 Series Command Line Reference
• clear timezone on page 106
• set summertime on page 140
• set timezone on page 143
• show summertime on page 160
• show timedate on page 161
• show timezone on page 161
set timezone
Sets the number of hours, and optionally the number of minutes, that the WSS’s real-time clock is offset from Coordi-
nated Universal Time (UTC). These values are also used by Network Time Protocol (NTP), if it is enabled.
Syntax
set timezone zone-name {-hours [minutes]}
Defaults
If this command is not used, then the default time zone is UTC.
Access
Enabled.
Examples
To set the time zone for Pacific Standard Time (PST), type the following command:
23x0# set timezone PST -8
Timezone is set to 'PST', offset from UTC is -8:0 hours.
See Also
• clear summertime on page 105
• clear timezone on page 106
• set summertime on page 140
• set timedate on page 142
• show summertime on page 160
• show timedate on page 161
• show timezone on page 161
zone-name Time zone name of up to 32 alphabetic characters. You can use a standard
name or any name you like.
- Minus time to indicate hours (and minutes) to be subtracted from UTC.
Otherwise, hours and minutes are added by default.
hours Number of hours to add or subtract from UTC.
minutes Number of minutes to add or subtract from UTC.