Hub/Switch Reference Guide

IP Services Commands 151
Nortel WLAN—Security Switch 2300 Series Command Line Reference
Defaults If you do not specify a start and end time, the system implements the time change
starting at 2:00 a.m. on the first Sunday in April and ending at 2:00 a.m. on the last Sunday in
October, according to the North American standard.
Access Enabled.
Usage You must first set the time zone with the set timezone command for the offset to work
properly without the start and end values.
Configure summertime before you set the time and date. Otherwise, summertime’s adjustment of the time will
make the time incorrect, if the date is within the summertime period.
Examples To enable summertime and set the summertime time zone to PDT (Pacific Daylight
Time), type the following command:
23x0# set summertime PDT
success: change accepted
See Also
• clear summertime on page 105
• clear timezone on page 106
• set timedate on page 142
• set timezone on page 143
• show summertime on page 160
• show timedate on page 161
• show timezone on page 161
set system ip-address
Configures the system IP address. The system IP address determines the interface or source IP address WSS
Software uses for system tasks, including the following:
• Mobility domain operations
• Topology reporting for dual-homed APs
• Default source IP address used in unsolicited communications such as AAA accounting reports and
SNMP traps
Syntax set system ip-address ip-addr
Defaults None.
min Minute to start or end the time change—a value between 0 and 59.
end End of the time change period.
ip-addr IP address, in dotted decimal notation. The address must be configured on one of the
WSS’s VLANs.