Hub/Switch Reference Guide

IP Services Commands 145

Nortel WLAN—Security Switch 2300 Series Command Line Reference

• set ip snmp server on page 118

• set snmp community on page 123

• set snmp notify profile on page 125

• set snmp protocol on page 135

• set snmp security on page 136

• set snmp usm on page 136

• show snmp notify target on page 159

set snmp protocol

Enables an SNMP protocol. WSS Software supports SNMPv1, SNMPv2c, and SNMPv3.

Syntax

set snmp protocol {v1 | v2c | usm | all} {enable | disable}

Defaults

All SNMP versions are disabled by default.

Access

Enabled.

History

Introduced in WSS Software Version 4.0.

Usage

SNMP requires the switch’s system IP address to be set. SNMP will not work without the system IP

address.

You also must enable the SNMP service using the set ip snmp server command.

Examples

The following command enables all SNMP versions:

WSS# set snmp protocol all enable

success: change accepted.