Hub/Switch Reference Guide

IP Services Commands 143
Nortel WLAN—Security Switch 2300 Series Command Line Reference
SNMPv2c with Informs
To configure a notification target for informs from SNMPv2c, use the following command:
Syntax set snmp notify target target-num ip-addr[:udp-port-number]
v2c community-string inform
[profile profile-name]
[retries num]
[timeout num]
SNMPv2c with Traps
To configure a notification target for traps from SNMPv2c, use the following command:
Syntax set snmp notify target target-num ip-addr[:udp-port-number]
v2c community-string trap
[profile profile-name]
target-num ID for the target. This ID is local to the WSS and does
not need to correspond to a value on the target itself.
You can specify a number from 1 to 10.
ip-addr[:udp-port-number] IP address of the server. You also can specify the UDP
port number to send notifications to.
community-string Community string.
profile profile-name Notification profile this SNMP user will use to specify
the notification types to send or drop.
retries num Specifies the number of times the WSS Software
SNMP engine will resend a notification that has not
been acknowledged by the target. You can specify
from 0 to 3 retries.
timeout num Specifies the number of seconds WSS Software waits
for acknowledgement of a notification. You can
specify from 1 to 5 seconds.
target-num ID for the target. This ID is local to the WSS and does
not need to correspond to a value on the target itself.
You can specify a number from 1 to 10.
ip-addr[:udp-port-number] IP address of the server. You also can specify the UDP
port number to send notifications to.
community-string Community string.
profile profile-name Notification profile this SNMP user will use to specify
the notification types to send or drop.