Hub/Switch Reference Guide

130 IP Services Commands
NN47250-100 (Version 02.51)
set ip telnet
Changes the TCP port number on which a WSS listens for Telnet management traffic.
Syntax set ip telnet port-num
Defaults The default Telnet port number is 23.
Access Enabled.
Examples The following command changes the Telnet port number on a WSS to 5000:
WSS# set ip telnet 5000
success: change accepted.
See Also
• clear ip telnet on page 102
• set ip https server on page 116
• set ip telnet server on page 120
• show ip https on page 152
• show ip telnet on page 155
set ip telnet server
Enables the Telnet server on a WSS.
Syntax set ip telnet server {enable | disable}
Defaults The Telnet server is disabled by default.
Access Enabled.
Caution! If you change the Telnet port number from a Telnet session, WSS Software
immediately ends the session. To open a new management session, you must Telnet to
the switch with the new Telnet port number.
port-num TCP port number.
Caution! If you disable the Telnet server, Telnet access to the WSS is also disabled.
enable Enables the Telnet server.
disable Disables the Telnet server.