Hub/Switch Reference Guide

128 IP Services Commands
NN47250-100 (Version 02.51)
• clear ip route on page 101
• show interface on page 149
• show ip route on page 153
set ip snmp server
Enables or disables the SNMP service on the WSS.
Syntax set ip snmp server {enable | disable}
Defaults The SNMP service is disabled by default.
Access Enabled.
Examples The following command enables the SNMP server on a WSS:
WSS# set ip snmp server enable
success: change accepted.
See Also
• clear snmp notify target on page 104
• set port trap on page 41
• set snmp community on page 123
• set snmp notify profile on page 125
set ip ssh
Changes the TCP port number on which a WSS listens for Secure Shell (SSH) management traffic.
Syntax set ip ssh port port-num
Defaults The default SSH port number is 22.
Access Enabled.
enable Enables the SNMP service.
disable Disables the SNMP service.
Caution! If you change the SSH port number from an SSH session, WSS Software
immediately ends the session. To open a new management session, you must configure
the SSH client to use the new TCP port number.
port-num TCP port number.