Hub/Switch Reference Guide
120 IP Services Commands
NN47250-100 (Version 02.51)
Defaults
None.
Access
Enabled.
Usage
You can assign one IP interface to each VLAN.
If an interface is already configured on the VLAN you specify, this command replaces the interface. If you replace an
interface that is in use as the system IP address, replacing the interface can interfere with system tasks that use the
system IP address, including the following:
• Mobility domain operations
• Topology reporting for dual-homed APs
• Default source IP address used in unsolicited communications such as AAA accounting reports and SNMP traps
Examples
The following command configures IP interface 10.10.10.10/24 on VLAN default:
WSS# set interface default ip 10.10.10.10/24
success: set ip address 10.10.10.10 netmask 255.255.255.0 on vlan default
The following command configures IP interface 10.10.20.10 255.255.255.0 on VLAN mauve:
WSS# set interface mauve ip 10.10.20.10 255.255.255.0
success: set ip address 10.10.20.10 netmask 255.255.255.0 on vlan mauve
See Also
• clear interface on page 99
• set interface status on page 112
• show interface on page 149
set interface dhcp-client
Configures the DHCP client on a VLAN, to allow the VLAN to obtain its IP interface from a DHCP server.
Syntax
set interface vlan-id ip dhcp-client {enable | disable}
Defaults
The DHCP client is enabled by default on an unconfigured 2350 when the factory reset switch is
pressed and held during power on.
The DHCP client is disabled by default on all other switch models, and is disabled on a 2350 if the switch is already
configured or the factory reset switch is not pressed and held during power on.
Access
Enabled.
History
Introduced in WSS Software Version 4.0.
Usage
You can enable the DHCP client on one VLAN only. You can configure the DHCP client on more
than one VLAN, but the client can be active on only one VLAN.
vlan-id VLAN name or number.
enable Enables the DHCP client on the VLAN.
disable Disables the DHCP client on the VLAN.