Hub/Switch Reference Guide

IP Services Commands 113
Nortel WLAN—Security Switch 2300 Series Command Line Reference
• set ntp on page 121
• set ntp server on page 122
• set ntp update-interval on page 122
• show ntp on page 156
clear ntp update-interval
Resets the NTP update interval to the default value.
Syntax clear ntp update-interval
Defaults The default NTP update interval is 64 seconds.
Access Enabled.
Examples To reset the NTP interval to the default value, type the following command:
WSS# clear ntp update-interval
success: change accepted.
See Also
• clear ntp server on page 102
• set ntp on page 121
• set ntp server on page 122
• set ntp update-interval on page 122
• show ntp on page 156
clear snmp community
Clears an SNMP community string.
Syntax clear snmp community name comm-string
Defaults None.
Access Enabled.
History Introduced in WSS Software Version 4.0.
Examples The following command clears community string setswitch2:
WSS# clear snmp community name setswitch2
success: change accepted.
comm-string Name of the SNMP community you want to clear.