Hub/Switch Reference Guide

112 IP Services Commands
NN47250-100 (Version 02.51)
See Also
• set ip route on page 116
• show ip route on page 153
clear ip telnet
Resets the Telnet server’s TCP port number to its default value. A WSS listens for Telnet management traffic on the
Telnet server port.
Syntax clear ip telnet
Defaults The default Telnet port number is 23.
Access Enabled.
Examples The following command resets the TCP port number for Telnet management traffic to its default:
WSS# clear ip telnet
success: change accepted.
See Also
• set ip https server on page 116
• set ip telnet on page 120
• set ip telnet server on page 120
• show ip https on page 152
• show ip telnet on page 155
clear ntp server
Removes an NTP server from a WSS configuration.
Syntax clear ntp server {ip-addr | all}
Defaults None.
Access Enabled.
Examples The following command removes NTP server 192.168.40.240 from a WSS configuration:
WSS# clear ntp server 192.168.40.240
success: change accepted.
See Also
• clear ntp update-interval on page 103
ip-addr IP address of the server to remove, in dotted decimal notation.
all Removes all NTP servers from the configuration.