Hub/Switch Reference Guide

IP Services Commands 111
Nortel WLAN—Security Switch 2300 Series Command Line Reference
clear ip dns server
Removes a DNS server from a WSS configuration.
Syntax clear ip dns server ip-addr
Defaults None.
Access Enabled.
Examples The following command removes DNS server 10.10.10.69 from a WSS’s configuration:
WSS# clear ip dns server 10.10.10.69
success: change accepted.
See Also
• clear ip dns domain on page 100
• set ip dns on page 113
• set ip dns domain on page 114
• set ip dns server on page 115
• show ip dns on page 151
clear ip route
Removes a route from the IP route table.
Syntax clear ip route {default | ip-addr mask | ip-addr/mask-length} default-router
Defaults None.
Access Enabled.
Examples The following command removes the route to destination 10.10.10.68/24 through router
10.10.10.1:
WSS# clear ip route 10.10.10.68/24 10.10.10.1
success: change accepted.
ip-addr IP address of a DNS server.
default Default route.
Note: default is an alias for IP address 0.0.0.0/0.
ip-addr mask IP address and subnet mask for the route destination, in dotted
decimal notation (for example, 10.10.10.10 255.255.255.0).
ip-addr/mask-length IP address and subnet mask length in CIDR format (for example,
10.10.10.10/24).
default-router IP address, DNS hostname, or alias of the next-hop router.