User's Manual
Table Of Contents
- Internal-Antenna Nortel Networks WLAN - Access Point Quick Installation Guide
- ATTENTION!
- Overview
- Step 1: Collecting Required Tools and Supplies
- Step 2: Configuring the Nortel Networks WLAN - Access Point Before Installation
- Step 3: Preparing Mounting Locations
- Step 4: Mounting the Nortel Networks WLAN - Access Points
- Step 5: Returning MAC Information
- Planning Notes
- Safety Considerations
March 16, 2004 17
Step 4: Mounting the Nortel Networks WLAN - Access Points
Note: The Nortel Networks WLAN - Access Point threaded holes have precision-depth threads.
Do not overtighten the screws, or the bracket will not fit under the screw heads.
Figure - Assembling the Mounting Screws and Spring Washers to the Nortel Networks WLAN - Access Point
• Copy the MAC address(es) from the label(s) on the Nortel Networks WLAN - Access Point onto
the corresponding location on the map. MAC addresses have the format 000B85xxxxxx.
• You have already attached the projection-mount L-bracket to the wall in Step 3: Preparing
Mounting Locations.
• Slide the screws into the keyhole slots on the mounting bracket as shown in the following
figure.
Note: If the screws do not securely hold the bracket, remove the Nortel Networks WLAN -
Access Point and adjust the screws until they securely hold the bracket.
Figure - Assembling the Nortel Networks WLAN - Access Point to the Projection-Mount Bracket