User's Manual

March 16, 2004 16
Step 4: Mounting the Nortel Networks WLAN - Access Points
• Snap the ceiling-mount clips onto a hanging ceiling rail.
Figure - Clipping the Nortel Networks WLAN - Access Point and Ceiling-Mount Clips to a Hanging-Ceiling Rail
• Attach the cables to the sides of the Nortel Networks WLAN - Access Point.
Note: Make sure the cables are routed away from the Nortel Networks WLAN - Access Point
antennas.
Note: When the Nortel Networks WLAN - Access Point is powered up and is associated with an
Nortel Networks WLAN - Wireless Security Switch (Green/Power and Yellow/802.11b/g and/or
Yellow or Amber/802.11a LEDs lit), the Nortel Networks WLAN - Access Point is broadcasting
its beacon signal(s). When this happens, complete the installation as quickly as possible to
remove yourself from within 8 inches (20 cm) of the Nortel Networks WLAN - Access Point to
comply with FCC RF radiation exposure guidelines.
You have installed the Nortel Networks WLAN - Access Point. Repeat Step 4: Mounting the Nortel
Networks WLAN - Access Points for each Nortel Networks WLAN - Access Point location, and then
continue with Step 5: Returning MAC Information
.
Projection Wall MountProjection Wall Mount
When you are mounting the Nortel Networks WLAN - Access Point out from a wall (flat sides along the
wall or hallway), use an optional factory-orderable projection-mount L-bracket.
• Before proceeding, gently screw the two factory-supplied screws and spring washers into the
bottom of the Nortel Networks WLAN - Access Point. Make sure the spring washers have their
convex (high center sections) pointing toward the screw heads.