User's Manual

March 16, 2004 14
Step 4: Mounting the Nortel Networks WLAN - Access Points
• Copy the MAC address(es) from the label(s) on the Nortel Networks WLAN - Access Point onto
the corresponding location on the map. MAC addresses have the format 000B85xxxxxx.
• Attach the ceiling-mount base to the bottom of the Nortel Networks WLAN - Access Point using
the factory-supplied machine screws and washers.
• Position the ceiling-mount base so its keyhole slots are partly on the drywall, sheet metal, or
other screw heads installed in Step 3: Preparing Mounting Locations
.
Note: If the screws do not securely hold the ceiling-mount base, remove the Nortel Networks
WLAN - Access Point and adjust the screws until they hold the ceiling-mount base securely.
• Attach the cables to the sides of the Nortel Networks WLAN - Access Point.
Note: When the Nortel Networks WLAN - Access Point is powered up and is associated with an
Nortel Networks WLAN - Wireless Security Switch (Green/Power and Yellow/802.11b/g and/or
Yellow or Amber/802.11a LEDs lit), the Nortel Networks WLAN - Access Point is broadcasting
its beacon signal(s). When this happens, complete the installation as quickly as possible to
remove yourself from within 8 inches (20 cm) of the Nortel Networks WLAN - Access Point to
comply with FCC RF radiation exposure guidelines.
• Slide the ceiling-mount base onto the drywall, sheet metal, or other screw heads until it snugs
into place.
You have installed the Nortel Networks WLAN - Access Point. Repeat Step 4: Mounting the Nortel
Networks WLAN - Access Points for each Nortel Networks WLAN - Access Point location, and then
continue with Step 5: Returning MAC Information
.