User Manual
Table Of Contents
- Internal-Antenna Nortel Networks WLAN - Access Point Quick Installation Guide
- ATTENTION!
- Overview
- Step 1: Collecting Required Tools and Supplies
- Step 2: Configuring the Nortel Networks WLAN - Access Point Before Installation
- Step 3: Preparing Mounting Locations
- Step 4: Mounting the Nortel Networks WLAN - Access Points
- Step 5: Returning MAC Information
- Planning Notes
- Safety Considerations
March 16, 2004 13
Step 4: Mounting the Nortel Networks WLAN - Access Points
Step 4: Mounting the Nortel Networks WLAN - Access PointsStep 4: Mounti ng the Nortel Networks WLAN - Access Points
Using the supplied or optional separately-orderable Nortel Networks WLAN - Access Point mounting
kits, mount each Nortel Networks WLAN - Access Point in its indicated location, oriented as shown on
the map. Note that you can mount the Nortel Networks WLAN - Access Points in the ceiling plenum or
below the ceiling, but the Nortel Networks WLAN - Access Points perform best when mounted below the
ceiling.
Note that the Nortel Networks 2200 series supports Antenna Sectorization, which can be used to
increase the number of clients and/or client throughput in a given air space. Installers can mount two
Nortel Networks WLAN - Access Points back-to-back and the Nortel Networks 2200 series operator can
disable the second antenna in both Nortel Networks WLAN - Access Points to create a 360-degree
coverage area with two sectors.
The Nortel Networks WLAN - Access Points can be mounted in one of three configurations:
• Ceiling Mount Base
• Ceiling-Mount Clips
• Projection Wall Mount
• Flush Wall Mount
Ceiling Mount BaseCe iling Mount Base
When you are mounting the Nortel Networks WLAN - Access Point in the middle of a ceiling (flat sides
toward the room or hallway), use the ceiling-mount base to mount the Nortel Networks WLAN - Access
Point as shown in the following figure and as described below:
Figure - Assembling the Nortel Networks WLAN - Access Point and Ceiling-Mount Base