User's Manual

Chapter 4 — Creating an equipment layout plan and a card slot assignment plan Page 73 of 332
Option 11C Mini Planning and Installation Guide
Equipment layout plan for installing the chassis on a table
To install an Option 11C Mini on a table, the available space on top of the
table must be large enough to hold the Main Chassis and Chassis Expander.
See Figure 11.
Note 1:
If you are installing only a Main Chassis now, leave enough
space for additional chassis to avoid problems in the future.
Note 2:
You can place the Main Chassis directly on top of the Chassis
Expander.
Leave enough wall space for the cross-connect terminal, the cross-connect
cables, and other equipment (such as a power supply for digit displays on
telephones).
CAUTION
Leave at least 12 in. (305 mm) of space between the top of the chassis
and any obstruction (such as a shelf) to permit enough air circulation.
Do not place the chassis on the floor, as dust can enter the system. This
results in damage to the system.