User's Manual

Page 216 of 332 Chapter 16 — Starting the Option 11C Mini and installing software
553-3021-209 Standard 3.00 April 2000
Procedure 29
Installing software
1 Make sure the MSC card is in CPU slot (slot 0) of the Main
Chassis.
For first-time installations, software is installed from the MSC card.
Software is loaded on the MSC card before it is sent to the customer
site.
2 Observe the terminal screen.
One of two messages appear, and the software installation continues
accordingly. If the message is:
INSERT SOFTWARE DELIVERY CARD
Go to Step 3.
OR if the following is displayed:
SOFTWARE INSTALLATION PROGRAM
go to Step 4 on page 217.
3 Skip this step unless you are using the Software Delivery (PCMCIA) to
install the software.
If you have not already done so, install the Software Delivery card
in Slot A in the socket in the faceplate of the MSC card.
Note:
You do not have to turn off the system power before you install
the Software Delivery card in Slot A.
See Figure 64.
Insert the card in slot A in the PCMCIA socket located in the faceplate
of the NTDK97 MSC card. Carefully press on the Software Delivery
card until it is firmly seated. See Figure 64.