User's Manual

Page 126 of 332 Chapter 9 — Installing the chassis
553-3021-209 Standard 3.00 April 2000
Figure 29
Chassis installed on a wall in a horizontal position
8 If you want to install a Chassis Expander on a wall in a horizontal
position, repeat the above steps for the Chassis Expander.
Refer to the equipment layout plan for the measurements and where
to position the Chassis Expander.
—————————— End of Procedure ——————————
Installing the chassis on a table
Items required
To install the chassis on a table, you require the following items:
• equipment layout plan
• four rubber feet
• four #8-32 machine screws
The NTTK10 kit contains all of the above items, with the exception of the
equipment layout plan.
Refer to Figure 30 for guidelines on how to position system components.