Server User Manual

Installing system grounds Page 99 of 488
Communication Server 1000E Installation and Configuration
2 Install a #6 AWG ground wire from the ground lug on the rear of the Media
Gateway Expander to the Media Gateway. See Figure 27 on page 97.
3 Place a DO NOT DISCONNECT tag on the ground wire.
4 Test the ground.
End of Procedure
Grounding other rack-mounted components
To ground multiple pieces of equipment in a rack, use a separate ground
connection from each piece of equipment to the ground bar. If a piece of data
communications equipment in a rack does not have a grounding lug then
ground the rack to the ground bar.
When the rack is grounded to the ground bar, the equipment is grounded
using the Single Point Grounding method, as shown in Figure 28 on
page 100.