Server User Manual

Page 477 of 488
Communication Server 1000E Installation and Configuration
484
Basic system telephony configuration
Contents
This section contains information on the following topics:
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 479
Basic system configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 479
MG 1000T card slot assignment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 484
TN assignment. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 485
Introduction
This chapter shows overlay (LD) sequences required to configure the system
with basic telephony features. Your Planning and Engineering group provides
the details needed to configure basic telephony.
Note: The Command Line Interface (CLI) must be used for some
configuration (for example, LD 10 and LD 11) before Element Manager
can be used to further configure basic telephony.
This chapter contains Procedure 123: "Configuring the basic system" on
page 480.
Basic system configuration
Programming the CS 1000E and MG 1000T systems requires loading
different overlay programs and using each one to enter a specific type of
information.