Server User Manual

Page 384 of 488 Installing Line cards and cross-connecting telephones
553-3041-210 Standard 4.00 September 2007
Before you proceed, install the cable from the slot that contains the Line card
associated with the telephone being connected. Refer to “Installing the Main
Distribution Frame” on page 353, if you require additional cable installation.
Refer to the Circuit Card: Description and Installation (553-3001-211) for
full descriptions of country-specific IPE cards and their installation
procedures
Figure 139 and Figure 140 on page 385 show the circuit card assignments for
the Media Gateway and Media Gateway Expander. Refer to these figures to
make sure that you have all circuit cards inserted in the correct slots.
DANGER OF ELECTRIC SHOCK
Always use caution when installing or modifying
telephone lines. Do not install telephone wiring during a
lightning storm. Do not install telephone jacks in wet
locations unless the jacks are designed for wet locations.
Never touch uninsulated telephone wiring unless the line
is disconnected at the network interface.