Server User Manual

Configuring an IP telephony node Page 379 of 488
Communication Server 1000E Installation and Configuration
• Cancel. Closes the Transfer / Status pages without performing any
action, and displays the Node Summary web page.
6 If the Signaling Server configuration was changed on the Edit web page,
reboot the Signaling Server.
End of Procedure
Adding a Follower Signaling Server to an
IP telephony node
Follow Procedure 96 to add a Follower Signaling Server to the IP telephony
node in Element Manager.
Procedure 96
Adding a Follower Signaling Server to the IP telephony node in
Element Manager
Note: After software installation and reboot, the Follower Signaling
Server sends out BootP requests and waits for a response. Because the
Follower Signaling Server has not booted successfully before, it waits for
a non-existing BootP response. Do not wait for this response; proceed to
the next steps.
In Element Manager:
1 Click Edit on the Node Configuration web page (see Figure 132 on
page 373).
2 Click Add beside the Signaling Server row.
3 Enter the Follower Signaling Server data to an IP telephony node. Include
the ELAN MAC address (used to answer BootP requests).
4 Click Save and Transfer to save the changes and the Leader Signaling
Server then obtains a copy of the node files.
5 Click OK to save the node configuration to the CS 1000E and transfer the
configuration to all elements.
When the file transfer is complete, the Transfer/ Status web page
appears.
The Leader Signaling Server responds to the Follower Signaling Server's
BootP request.
The Follower Signaling Server initializes its network interfaces.