Server User Manual

Installing and configuring a Voice Gateway Media Card Page 349 of 488
Communication Server 1000E Installation and Configuration
The Network and Peripheral Diagnostics web page opens, as shown in
Figure 121 on page 346.
4 Select the DISU – Disable unit command from the Unit Commands
drop-down list.
5 Enter the card number and unit number in the corresponding Command
Parameter text box.
6 Click Submit to the right of the text box.
The output from this command is shown in the text box in the lower half
of the web page.
End of Procedure
Enabling a card
Follow Procedure 87 to enable a Voice Gateway Media Card using
Element Manager.
Procedure 87
Enabling a Voice Gateway Media Card using Element Manager
1 Select System > Maintenance from the navigator.
The Maintenance web page opens as shown in Figure 119 on page 344.
This page allows you to perform maintenance using overlays or using a
selected functionality. The default is overlay, as shown in Figure 119.
2 Select Select by Functionality.
The list in the web page changes to show a list of diagnostics you can use,
as shown in Figure 120 on page 345.
3 Select Network & Peripheral Equipment Diagnostics from the list in
Figure 120 on page 345.
The Network and Peripheral Diagnostics web page opens, as shown in
Figure 121 on page 346.
4 Select the ENLC – Enable and reset card command from the Card
Commands drop-down list.
5 Enter the card number in the corresponding Command Parameter text
box.
6 Click Submit to the right of the text box.