Server User Manual

Installing and configuring a Voice Gateway Media Card Page 327 of 488
Communication Server 1000E Installation and Configuration
The VGW channels for this card are displayed. See Figure 104 on
page 327.
Note: If you receive an error that a pad category table does not exist for
this customer, go back to your DTI configuration step, (see “Basic system
telephony configuration” on page 479) and create a default DTI Data
Block (DDB), and then perform this procedure again.
Figure 104
VGW channels list
End of Procedure
Configuring voice gateway channels using LD 14
The voice gateway channels are also called “DSP channels” or the card’s
“physical TNs.” Follow Procedure 78 on page 328 to configure the voice
gateway channels using LD 14.