Server User Manual

Installing and cross-connecting a trunk card Page 295 of 488
Communication Server 1000E Installation and Configuration
Note: See “Installing and cross-connecting a Power Fail Transfer Unit”
on page 441 for connecting trunks with the PFTU.
End of Procedure
Universal Trunk card connections
The Universal Trunk card (NT8D14) provides eight Analog trunks that can
function in the modes identified in Table 20. Refer to Table 21 on page 296
for the connections to the Universal trunk at the cross-connect terminal.
Table 20
NT8D14 Universal Trunk card – modes and option settings
Modes Location Jumper strap
Central (CO) J1, J2 OFF
2-way TIE trunk (loop Dial Repeat) J1, J2 OFF
2-way TIE trunk (Outgoing Incoming
Dial)
J1, J2 OFF
Recorded Announcement (RAN) J1, J2 OFF
Paging trunk J1, J2 OFF
Japan CO/DID operation J1, J2 OFF
DID operation
Loop length>2000 ohms
J1, J2 ON
DID operation
Loop length <2000 ohms
J1, J2 OFF
Note 1: OFF indicates that no strap is present.
Note 2: J1 and J2 locations apply to all eight trunks.