Server User Manual

Page 274 of 488 Configuring a terminal and SDI ports
553-3041-210 Standard 4.00 September 2007
Figure 90
Maintenance to Signaling Server connection
2 The COM port on the PC Maintenance terminal should be set as follows:
• Terminal type: VT100
• Speed: 19200
• Data bits: 8
• Parity: none
• Stop bits: 1
• Flow control: none
After the installation, the Signaling Server maintenance port speed can be
changed. See Signaling Server: Installation and Configuration
(553-3001-212).
End of Procedure
BayStack 470 SDI connection
The SDI port on the Bay Stack 470 can be used for basic configuration and
maintenance. The SDI port is located on the faceplate. It is a DCE port with
a default speed of 9600 bps.
Media Card SDI connection
The SDI ports on a Media Card can be used for basic configuration or
maintenance. Figure 91 shows the maintenance port location on the Media
Card and the Shielded 50-pin to Serial/ELAN/TLAN adapter.
PC Maintenance
Terminal
serial