Server User Manual

Configuring a terminal and SDI ports Page 273 of 488
Communication Server 1000E Installation and Configuration
Signaling Server SDI connection
The Signaling Server has two maintenance ports: the Front port and the
Console port (see Figure 89). The Console port must be used to install the
Signaling Server software to perform the basic configuration.
Figure 89
Signaling Server maintenance port locations
Procedure 70
Connecting the maintenance PC to a Signaling Server
1 Connect a DTE–DTE null modem serial cable (supplied with the Signaling
Server) from the Console port to a PC workstation.
Note: The Signaling Server is shipped with the Admin/Serial port set to
19200 bit/s.
During the initial installation, the unit requires the PC Maintenance
terminal settings as provided in Step 2 on page 274.
Front port
Console port