Server User Manual

Page 267 of 488
Communication Server 1000E Installation and Configuration
276
Configuring a terminal and SDI ports
Contents
This section contains information on the following topics:
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 267
Setting the TTY terminal port . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 268
Traditional terminal SDI connection. . . . . . . . . . . . . . . . . . . . . . . . . . . 268
CS 1000E Core Call Server SDI connection. . . . . . . . . . . . . . . . . . . . . 269
MG 1000E SDI connection. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 270
MG 1000T SDI connection. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 270
Signaling Server SDI connection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 273
BayStack 470 SDI connection. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 274
Media Card SDI connection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 274
Introduction
In the CS 1000E system, each stand-alone module (Call Server, MG 1000E,
MG 1000T, Signaling Server, and Baystack switch) has a Serial Data
Interface (SDI) port to be used for software installation and maintenance
access. The SDI port can be accessed by running a Telnet session through the
Terminal Server locally or remotely. See “Configuring a Terminal Server” on
page 255 for Terminal Server Setup. The SDI port can also be accessed by a
local terminal through the SDI connection.