Manualshelf

Server User Manual

ManualsBrandsNortel Networks ManualsTelephone1000E
231232233234235236237238239240
Page 234 of 488 Configuring a Small System Controller
553-3041-210 Standard 4.00 September 2007
3 Install the 100BaseT daughterboard (single port) in slot 2 of the SSC:
a. Locate the alignment pin on the SSC.
b. Insert the alignment pin into the appropriate hole on the 100BaseT
daughterboard (single port).
c. Secure the 100BaseT daughterboard (single port) using metal
screw-downs on the SSC.
d. Route the NTDU0606 Ethernet cable through the plastic guides on
the SSC.
4 Install the SSC in the Media Gateway.
5 Connect the NTDU0606 Ethernet cable to port 1 of the Media Gateway
bulkhead connector shown in Figure 85 on page 234.
6 Repeat Step 1 to Step 5 for each Media Gateway.
Figure 85
Bulkhead connector on a Media Gateway
End of Procedure
Port 1