Server User Manual

Configuring a Small System Controller Page 229 of 488
Communication Server 1000E Installation and Configuration
4 Install the 100BaseT daughterboard (dual port) in slot 2 of the SSC:
a. Locate the alignment pin on the SSC.
b. Insert the alignment pin into the appropriate hole on the
daughterboard.
c. Secure the 100BaseT daughterboard (dual port) using metal
screw-downs on the SSC.
d. Route the NTDU0606 Ethernet cable(s) through the plastic guides on
the SSC.
Figure 82 on page 230 shows an SSC with two 100BaseT
Daughterboards (dual port).
5 Install the SSC in a Media Gateway.
6 Connect each labeled Ethernet cable to the corresponding port number
bulkhead connectors.
7 Reinstall the front cover.
End of Procedure
CAUTION — Service Interruption