Server User Manual

Page 200 of 488 Configuring the CS 1000E Call Server
553-3041-210 Standard 4.00 September 2007
Introduction
The CS 1000E system requires the configuration of an IP telephony node.
The configuration data is stored in the BOOTP.TAB and CONFIG.INI files
on the CS 1000E. Copies of both files are maintained on each node
component (Signaling Server and Media Card).
The preconfigured IP telephony configuration files from the leader Signaling
Server must be imported. These files are saved on the CS 1000E as:
• c:/u/db/node/nodex.cfg where x is the node number
• c:/u/db/node/nodex.btp where x is the node number
The node database files are backed up along with the customer database using
the LD 43 EDD command.
This chapter contains the following procedures:
• Procedure 47: "Enabling the Login Name option" on page 201
• Procedure 48: "Configuring login IDs and passwords" on page 203
• Procedure 49: "Enabling the multi-user option" on page 206
• Procedure 50: "Configuring pseudo-terminals (PTYs)" on page 207
• Procedure 51: "Checking PTY status" on page 209
• Procedure 52: "Configuring MG 1000E Bandwidth Management Zone"
on page 211
• Procedure 53: "Launching Element Manager" on page 216
• Procedure 54: "Importing an existing node" on page 219
• Procedure 55: "Performing a datadump using Element Manager"
on page 221
IMPORTANT!
Do not attempt to alter the configuration files either manually or with
OTM’s ITG or IP Phone management. Use Element Manager only.