Server User Manual

Installing and configuring the Signaling Server software Page 195 of 488
Communication Server 1000E Installation and Configuration
Figure 75
Quit
18 Remove the CD-ROM from the drive and reboot the system.
Note: After software installation and reboot, a Follower Signaling Server
sends out BOOTP requests and waits for a response. Since the Follower
Signaling Server is not yet configured in an IP Telephony node, there is
no BOOTP response. For more information see Signaling Server:
Installation and Configuration (553-3001-212).
End of Procedure
Use Element Manager to install the Follower Signaling Server in the
IP Telephony node.
Logging in to the Signaling Server
Use Procedure 45 on page 196 to log in to the vxWorks
TM
shell to access the
Signaling Server from a maintenance terminal.
CS 1000 Signaling Server Software Install Tool (sse-x.xx.xx)
=====================================================================
You have selected to quit the Install Tool.
Before quitting and rebooting the system, remove all disks (floppy,
CDROM) from the drives.
Please enter:
<CR> -> <m> - Return to previous menu.
<q> - Quit and reboot the system.
Enter Choice> q