Server User Manual

Installing software on the CS 1000E Page 141 of 488
Communication Server 1000E Installation and Configuration
3 Wait for “DONE” and then “INI” messages to display before you continue.
End of Procedure
Test the Call Server
Procedure 26
Testing the Call Server
1 Verify that the Call Server is active.
2 Check dial-tone.
3 Verify that the Call Server is active, redundant, and single.
4 Make internal, external, and network calls.
5 Check attendant console activity.
6 Check IP Peer networking for incoming and outgoing calls.
7 Check applications (CallPilot, Symposium, and so on).
End of Procedure
Install the software on the second Call Server
Procedure 27
Installing the software on the second Call Server
1 Attach the LAN 1 and LAN 2 cables to the CP PIV faceplate connectors
between the Call Servers.
2 Complete procedures 22 through 27 for the second Call Server.
3 Each Call Server can be named: Call Server 1 and Call Server 0.
Note: Do not install LAN 1 and LAN 2 cables at this time.
End of Procedure
LD 135 Load program
STAT CPU Get the status of the CPUs