Owner's manual

ManualsBrandsNortel Networks ManualsVideo surveillance systems1000

481

482

483

484

485

486

487

488

489

490

Introduction 487

Table 205

Trunk and signaling matrix

Trunk types

Signaling type

CO/FX/

WATS DID Tie RAN Paging CAMA

Loop start Yes No

(see no

te)

No N/A N/A Yes

Ground start Yes No No N/A N/A No

Loop DR No Yes Yes N/A N/A No

Loop OAID No No Yes N/A N/A No

Continuous operation mode No No No Yes N/A No

Start modes (pulse and level) No No No Yes N/A No

Note: For incoming and outgoing service, DID trunks must be programmed as loop dial repeating.

The Universal Trunk Card has eight identical units. You configure the trunk

type of each unit independently in the Trunk Data Block (LD 14). The card

supports the following types of trunks:

• Central Office (CO), Foreign Exchange (FX), and Wide Area

Telephone Service (WATS)

•

Direct Inward Dial (DID) and Direct Outward Dial (DOD)

•

Tie Two-way Dial Repeating (DR) and Two-way Outgoing Automatic

Incoming Dial (OAID)

•

Paging (PAG)

Note: All-call zone paging is not supported.

•

Recorded Announcement (RAN).

The Universal Trunk Card also supports Music, Automatic Wake Up, and

Direct Inward System Access (DISA).

Table 206 "Supported trunk type and signaling matrix" (page 488) is a

matrix of the trunk types and signaling supported by the Universal Trunk

Card.

Nortel Communication Server 1000

Circuit Card Reference

NN43001-311 02.06 Standard

27 August 2008