Owner's manual

ManualsBrandsNortel Networks ManualsVideo surveillance systems1000

401

402

403

404

405

406

407

408

409

410

406 NT6D80 MSDL card

Enabling the MSDL

Enter ENL MSDL x to enable the MSDL manually. If the MSDL base code

has not been previously downloaded or if the card version is different from

the one on the system disk, the software is downloaded and the card is

enabled.

To force software download and enable the card, enter ENL MSDL x FDL.

This command forces the download of the MSDL base code and the

configured peripheral software even if it is already resident on the card.

The card is then enabled.

To enable a disabled MSDL and its ports, enter ENL MSDL x ALL. This

command downloads all peripheral software (if required) and enables any

configured ports on the card. This command can be issued to enable

some manually disabled ports on an already enabled MSDL.

Disabling the MSDL

To disable an MSDL card, enter DIS MSDL x.

To disable the MSDL and all its ports, enter DIS MSDL x ALL.

Resetting the MSDL

To reset an MSDL and initiate a limited self-test, the MSDL must be in a

manually disabled state. To perform the reset, enter RST MSDL x.

Displaying MSDL status

To display the status of all MSDL cards, enter STAT MSDL.

To display the status of a specific MSDL, enter STAT MSDL x. The status

of the MSDL, its ports, and the operation of each port appears.

The command STAT MSDL x FULL displays all information about an MSDL

(card ID, bootload firmware version, base code version, base code state,

operation state, date of base code activation) as well as the version, state,

and activation date for each card operation.

Self-testing the MSDL

To perform extensive self-testing of an MSDL, enter SLFT MSDL x. This

test can be activated if the card is in the manually disabled state. If the test

passes, the system outputs the card ID and a pass message. If it fails, the

system displays a message indicating which test failed.

Manually isolating and correcting faults

Problems are due to configuration errors that occur during installation or

hardware faults resulting from component failure during operation. See

“Symptoms and actions” (page 409) for more information on problem

symptoms and required responses.

Nortel Communication Server 1000

Circuit Card Reference

NN43001-311 02.06 Standard

27 August 2008