User's Manual

Welcome
Thank you for choosing Numera Libris.
This user guide provides key information about Libris, including Important Safety Information.
Please review it carefully and keep it nearby for reference. If you have questions that are not
addressed in the user guide, please call your customer service number.
Libris is also available with telehealth functionality, providing safety and mobile health
monitoring in one device. Your response team can provide more information.
Some features and audio prompts described in this User Guide may not
apply to your device. Device settings vary by response team.
About Libris
Libris, a personal mobile responder, is cellular-enabled and designed to provide you personal
emergency response services whether you are at home, away from home, and even in the
shower or bath.
Libris can be activated by:
• Pressing the Libris Call Button.
• Detecting a fall while wearing the Libris (if this option is enabled).
• Triggering an optional Pendant Calling Device locally in your home while the Libris is
charging in its Smart Cradle.
When activated, Libris will automatically call and allow you to speak with your response team
and provide information about your location. Your response team can then notify emergency
services for you, if needed.
Libris
Calling Devices
Accessories
Belt ClipPower Cord
Help-Pendant
Fall-Pendant
Wrist-Pendant
Smart Cradle
Important Safety Information
FOR PROPER OPERATION, LIBRIS REQUIRES ADEQUATE CELLULAR COVERAGE.
POOR CELLULAR COVERAGE MAY RESULT IN THE INABILITY TO PLACE A CALL OR
AUTOMATICALLY DETECT A FALL. Check with your customer service team for known
coverage limitations.
As with all location-based services, it may not always be possible to determine your
location. Multi-level buildings, parking garages, and even dense urban areas can
make it diffi cult for satellites and cell phone towers to determine your exact location.
In an emergency, please provide your response team with as much information as
possible about your location.
Libris is not a replacement for regular contact with caregivers or access to an
alternative means of placing an emergency call.
While the fall detection system performs well, no such system is 100% reliable. If you
experience a fall that causes actual or potential injury, do not wait for the automatic
call. You should always press the Call Button manually in an emergency if you are able.
Libris requires adequate battery charge for proper operation. Low battery may result
in the inability to place a call, automatically detect a fall, and/or properly locate you
automatically during an emergency.
Libris is designed to be highly water-resistant, not waterproof. Usage other than as
directed may result in the inability to place a call, automatically detect a fall, and/or
properly locate you automatically during an emergency.
Use only the Numera-provided Smart Cradle and Power Cord. Keep the Smart Cradle
and Power Cord in good condition and located where they do not pose a safety hazard.
Use only the Numera-provided Lanyard. To reduce risk of strangulation, the Libris
Lanyard is designed to break apart under certain conditions. Any cord worn around
the neck, however, can pose a risk of strangulation, including the possibility of
serious injury and death. Libris users and caregivers should exercise care with the
Lanyard to ensure it does not get caught or tangled in wheelchairs, walkers and other
such equipment.
Do not modify or dismantle Libris at any time, as this will void the warranty. The
battery in Libris is not designed to be removed or replaced. There is a risk of explosion
if the battery is tampered with, replaced with an incorrect type or manipulated in any
way.
Hold Libris a minimum of 1 inch away from your body with the microphone near your
mouth to complete an emergency call.
Test this System weekly. It is strongly recommended that you test this equipment at
least weekly to ensure the System is working properly.
Each user in the household must have their own Libris and Smart Cradle. An optional
Pendant Calling Device may not place an emergency call for you if another user’s
Libris is in your Smart Cradle.
In case there is more than one subscriber in a household, contact your customer
service for details on operation in a multi-subscriber environment. All Libris users in
a single household must use the same service provider.
An optional Pendant Calling Device cannot place an emergency call if the Smart
Cradle has not been programmed to recognize the optional Pendant Calling Device.
User Guide
Libris Overview
1. Cellular Indicator shows cellular signal strength
2. Battery Indicator, which surrounds the Call Button, shows battery status
3. Call Button, when pushed, initiates a two-way call to your response team
4. Speaker allows you to hear your response team
5. Microphone allows response team to hear you
6. Clip Lock enables you to affi x a Lanyard/Clip or Belt Clip
7. Charging Pins connect Libris to the Smart Cradle (be sure to keep these clean)
Smart Cradle Overview
1. Smart Cradle is for holding Libris while charging or when
using optional Pendant Calling Devices
2. Charging Pins connect Smart Cradle to the Libris (be sure to keep these clean)
3. Internal UHF radio receiver is for local monitoring of optional Pendant Calling Devices
4. Power Port is where the low voltage barrel connector of
the Power Cord connects to the Smart Cradle
5. Program Indicator, lights red while pairing optional Pendant Calling Devices
6. Program Button is used the pair optional Pendant Calling Devices to the Smart Cradle
7. Power Cord connects the Smart Cradle’s Power Port to a standard wall outlet
Activation and Set Up
Step 1: Activate Libris
1. Plug the small round end of the Power Cord into
the Power Port located in the back of the Smart
Cradle. Plug the large end of the Power Cord into a
non-switched standard wall outlet (an outlet not
controlled by a wall switch).
2. Place Libris into the Smart Cradle. While charging,
the Cellular and Battery Indicators will be on and
show your current cellular signal strength and level
of battery charge.
3. Libris will automatically turn on when placed in the
Smart Cradle and will play a short start up tone,
followed by a message indicating it is ready for its
fi rst use: “We are activating your personal mobile
responder. We will notify you when activation is
complete.” Libris will automatically receive any
updates and, once activated on the cellular network,
will say: “Activation is now complete. We are
resetting your personal mobile responder so it is
ready for your use. One moment please.” Allow up to
a minute for Libris to restart.
4. Libris will then play a message: “This personal
mobile responder will notify your response team
when it detects a fall. With one touch of the call
button your response team will be available to assist
you and will pinpoint your location so help can reach
you.”
Step 2: Call to Complete Set Up
1. To register your personal mobile responder with
your response team, Libris will say: “It’s time to
meet your response team. Please press and hold
the Call Button down to connect to your response
team now.”
2. With Libris in the Smart Cradle, press and hold
the Call Button until Libris initiates the call. Libris
can remain in the Smart Cradle during the call to
your response team.
3. Listen for the audio message: “Calling your response team now.”
4. When you complete the call with your response team, Libris will be set up.
Important: Libris is not ready for use until you have completed the set up
call with your response team and, following that call, have charged Libris
in the Smart Cradle for 4 hours.
✎ Note: If Libris does not power on and begin the activation process or cannot
detect a cellular network, call your customer service number.
Step 3: Add Optional Pendant Calling Devices
The Libris Smart Cradle can be programmed to recognize optional Pendant Calling Devices.
To add optional Pendant Calling Devices:
1. Be sure the Libris is in the Smart Cradle and the Smart
Cradle is powered on.
2. Press and release the Program button on the rear of
the Smart Cradle. The Program indicator will blink
amber.
3. Within 20 seconds, activate a Pendant.
4. The Program indicator should light green when the
Pendant is recognized.
5. Repeat Steps 1-4 for up to 8 additional Pendants.
Important: When using optional Pendant
Calling Devices, the Smart Cradle should be
installed centrally located in the residence.
Step 4: Testing Optional Pendant Calling Devices
If optional Pendant Calling Devices are added, they must be tested throughout the installation
to determine their usable locations. Use two people for this test:
Caution: Before testing, call customer service to
notify them that you will be testing.
1. Be sure the Libris is in the Smart Cradle and the Smart
Cradle is powered on.
2. Have one person with the Pendant go to various test
locations around the residence where the Pendant
might be used and press the button on the Pendant.
3. Have the other person stand by the Libris. With each
test, listen for the chime alert and the audio message:
“Calling your response team now”, confi rm each test
was received by the response team.
4. Note any locations that fail the test. The Pendant
should not be relied on at any locations that fail
the test.
Important: Pendant Calling Devices can only place an emergency call if the
Libris is resting in the Smart Cradle and the Smart Cradle Power Cord is
plugged into AC power.
Important: Pendant Calling Devices do not have a speaker or microphone,
talk to the response team through the Libris unit. If an emergency call is
placed by an Pendant Calling Device when you are not nearby the Libris in
its Smart Cradle, you may not be able to hear the response team, and the
response team may not be able to hear you.
PRESS
BLINKS
AMBER
GREEN
PRESS
Battery Indicator
The Battery Indicator, which surrounds the Call Button, shows the level of battery charge.
• When the Battery Indicator is green, Libris is adequately charged.
• When the Battery Indicator is amber, Libris is moderately charged.
• When the Battery Indicator is red, the battery charge is low, Consider charging soon.
Battery Indicator Status* Action Required
Green Good Ready for use
Amber Moderate No action needed
Red Low Charge soon
*The Libris battery is designed to operate on a single charge for 36 hours but may be
reduced as a result of user activity, cellular coverage, talk time, device-specifi c settings, and
device life.
Important: Libris requires an adequate battery charge to function properly.
Prior to use, please charge Libris at least 4 hours. We recommend charging
the device each night.
Cellular Indicator
The Cellular Indicator on top of Libris shows cellular signal strength.
• When the Cellular Indicator is green, Libris has a strong signal.
• When the Cellular Indicator is amber, Libris has a moderate signal.
• When the Cellular Indicator is red, Libris has no signal. Move to an area where you get a
cellular signal. Libris will not function properly without an adequate cellular signal.
Cellular Indicator Strength*
Green Strong
Amber Moderate
Red No signal
*A cellular signal may not be available in all areas.
Indicator Light Settings
The cellular and battery indicator light settings may be confi gured by your response team to
fl ash at a regular interval or activate by quickly pressing the Call Button.
Sleep Mode
Any time Libris is placed in the Smart Cradle, it will enter Sleep Mode cycles for approximately
one hour. During this time, the cellular signal strength indicator light will turn off or fl ash red.
Libris will automatically exit Sleep Mode if the Call Button is pressed, the device is removed
from the Smart Cradle, or it is between Sleep Mode cycles.
Important: Libris requires an adequate cellular signal to function properly.
Check with your customer service team for known coverage limitations.
Wearing Libris
Libris can be worn on a belt using the Belt Clip, or as a pendant around your neck using
the Lanyard/Clip. If worn with the Lanyard, Libris should be worn under clothing to prevent
excess movement of the device.
Important: Libris requires a vertical position with the Call Button facing
away from the body to operate properly.
Attaching Belt Clip or Lanyard/Clip
1. Align the notched side of the Clip with the notched area on the back.
2. Press inward until the Clip notches are nested within the Libris notches.
3. Firmly push the Clip toward the top of the device. It is secure when you hear a click
or you can no longer see the notches on the Clip.
Removing the Clip
1. Hold Libris in your hand as shown, with the Call
Button facing the palm of your hand.
2. Forcefully push downward on the Clip with your
thumb.
Turning On and Off
To turn Libris on, press the Call Button and hold it until the Battery Indicator fl ashes.
Libris will play music while it starts up. Once connected, Libris will play a message: “Your
personal mobile responder is ready.”
Placing Libris into the Smart Cradle will turn it on automatically. Start-up audio prompts are
silenced while this function is carried out in the Smart Cradle.
To turn Libris off, press the Call Button twice, holding down the second press for 7 seconds
until Libris plays a message announcing that you have requested to turn it off. It will ask
you to confi rm by pressing the Call Button one more time. If done correctly, Libris will play
the following message: “Powering off now. Good bye.”
✎ Note: When you fi rst receive Libris, leave it in the Smart Cradle for 4 hours.
Lanyard/Clip
PRINTER’S INSTRUCTIONS: INSTRUCTIONS, USER GUIDE, LIBRIS BT CHARGER; P/N: 10011246 X1; MATERIAL: 80GSM WOOD FREE PAPER; INK: BLACK & PMS 032 (RED); SIZE: FLAT 19.000” x 17.000” FOLDED: 4.750” x 2.833”; FOLDING: MAP FOLD TO 4.750” x 2.833”; TOLERANCE ± .125”; SCALE: 1-1; SIDE 1 OF 2