PRINTER’S INSTRUCTIONS: INSTRL,INSTL,RI-C - LINEAR P/N: 214601 X1 - INK: BLACK - MATERIAL: 20 LB. MEAD BOND - SIZE: 8.500” X 5.500” - SCALE: 1-1 - FOLDING: ALBUM FOLD - BINDING: SADDLE-STITCH WIRELESS INTERCOM SYSTEM 5-CHANNEL RADIO INTERCOM Installation & Operation Instructions (760) 438-7000 • FAX (760) 438-7043 USA & Canada (800) 421-1587 & (800) 392-0123 Toll Free FAX (800) 468-1340 www.linearcorp.
TABLE OF CONTENTS CONSOLE DESCRIPTION.......................................................................................... a CONSOLE FEATURES ...............................................................................................b DOORBELL FEATURES .............................................................................................1 CONSOLE ANTENNA ...............................................................................................2 PROGRAMMING THE STATIONS .................
CONSOLE FEATURES 4 2 1 3 5 12 6 11 10 7 9 8 1. STATION INDICATORS Indicators light when a station number button is pressed to show the station(s) that will be called. Indicators blink to show a call in progress. Indicators flash during conversation to show the busy stations. 2. STATION BUTTONS Press a button to select the intercom station(s) to be called. Pressing again de-selects the station. 3. STATION LABEL AREAS For applying labels that identify the intercom station locations. 4.
DOORBELL FEATURES 2 5 1 6 3 7 4 10 11 9 8 1. MICROPHONE High-gain microphone monitors audio while the Doorbell’s TALK button is pressed. 2. SPEAKER Sounds audio from the intercom Console. Volume is adjustable with the volume control (see Item #6). 3. POWER INDICATOR Lights to show that Doorbell power is on. Doorbell power automatically switches ON when TALK button is pressed. The power automatically switches OFF 15 seconds after the last intercom communication. 4.
CONSOLE ANTENNA SWING ANTENNA OUT FROM BOTTOM OF CASE FOR TABLE OR SHELF MOUNTING... SWING ANTENNA ALL THE WAY UP FOR WALL MOUNTING...
PROGRAMMING THE STATIONS 1 BRING ALL UNITS TOGETHER THAT ARE GOING TO BE USED IN THE SYSTEM NOTE: FOR BEST PERFORMANCE KEEP UNITS AT LEAST 6 FEET APART FROM EACH OTHER TURN CONSOLE(S) POWER KNOB OFF DOORBELL CONSOLE CONSOLE PLUG IN CONSOLE(S) TRANSFORMER CONNECT DOORBELL(S) BATTERIES 2 SET SWITCHES SET ALL FREQUENCY SWITCHES THE SAME (A OR B) A CONSOLE SET FREQUENCY B DOORBELL SET ALL CONSOLE MUTE SWITCHES TO OFF 3 SET ALL UNITS INTO PROGRAM MODE DOORBELL PROGRAM BUTTON INSIDE HOLE CONSOLE
PROGRAMMING THE STATIONS 4 SET STATION NUMBERS 4 ON EACH CONSOLE, PRESS A STATION NUMBER BUTTON TO SET THAT CONSOLE'S STATION NUMBER (SELECT A DIFFERENT NUMBER FOR EACH CONSOLE) 5 DOORBELL DOORBELLS CAN BE SET FOR STATION 4 OR 5 THE STATION NUMBER INDICATOR WILL STAY LIT SET STATION SWITCH TO 5 FOR "DING-DONG", OR TO 4 FOR "DONG" CHIME WHEN DOORBELL BUTTON IS PRESSED (TO TELL FRONT FROM BACK DOOR) APPLY LABELS TO DESCRIBE THE LOCATIONS CONSOLE 5 SET STATION DOORBELL BEEPS 10 TIMES THEN TURNS ITS
WALL MOUNTING THE DOORBELL NOTE: DO NOT MOUNT THE DOORBELL UNIT WHERE IT WILL BE EXPOSED TO EXCESSIVE MOISTURE, DUST, OR IN DIRECT SUNLIGHT 1 USE MOUNTING PLATE AND PENCIL TO MARK SCREW LOCATIONS 2 ATTACH MOUNTING PLATE USING THE SCREWS PROVIDED 3 TILT DOORBELL INTO MOUNTING PLATE 4 SECURE DOORBELL TO MOUNTING PLATE WITH THE CASE LOCKING SCREW NOTE: WAIT UNTIL AFTER ADJUSTING THE DOORBELL AUDIO VOLUME BEFORE FULLY TIGHTENING THE LOCKING SCREW 6 214601 X1 - IMAGE 8
WALL MOUNTING THE CONSOLE NOTE: DO NOT MOUNT THE CONSOLE OUTDOORS, OR WHERE IT WILL BE EXPOSED TO EXCESSIVE MOISTURE, DUST, OR IN DIRECT SUNLIGHT LEFT SCREW ROUTE TRANSFORMER WIRE INTO WIRING SLOT MARK SCREW LOCATIONS AND DRIVE IN SCREWS LEAVING HEADS ABOUT 1/4" OUT MOUNT CONSOLE ON WALL SCREWS RIGHT SCREW 7 214601 X1 - IMAGE 9
OPERATING THE DOORBELL & CONSOLE 1 THE VISITOR MAKES THE CALL GREEN POWER INDICATOR LIGHTS WHILE DOORBELL POWER IS ON THE VISITOR PRESSES THE DOORBELL-TALK BUTTON NOTE: THE CONSOLE POWER MUST BE ON, AND THE VOLUME MUST BE SET ABOVE MINIMUM DOORBELL 2 CONSOLE ANNOUNCES THE VISITOR EACH CONSOLE WILL CHIME A "DING-DONG" (FOR STATION 5) OR A "DONG" (FOR STATION 4) NOTE: IF A CONSOLE'S MUTE SWITCH IS "ON", THE DOORBELL CHIME WILL NOT SOUND CONSOLE 3 SEE THE VISITOR'S LOCATION THE CONSOLE WILL INDICATE
OPERATING MULTIPLE CONSOLES SELECTIVE STATION CALL EXAMPLE: GARAGE IS CALLING KITCHEN 1 STATION INDICATOR LIGHTS CHOOSE WHOM TO CALL WITH CONSOLE POWER ON, PRESS THE BUTTON FOR THE CONSOLE THAT YOU WANT TO CALL (DOORBELLS CAN NOT BE CALLED) NOTE: MORE THAN ONE STATION CAN BE CHOSEN, BUT ONLY ONE STATION CAN RESPOND AT A TIME 2 GARAGE CONSOLE STATION INDICATOR STAYS LIT MAKE THE CALL PRESS AND HOLD THE TALK BUTTON, SPEAK TOWARDS THE CONSOLE RELEASE THE TALK BUTTON WHEN YOU ARE FINISHED TALKING GARAG
OPERATING MULTIPLE CONSOLES STATION ALL-CALL EXAMPLE: KITCHEN IS CALLING EVERYONE 1 CHOOSE STATION ALL-CALL ALL STATION INDICATORS LIGHT WITH CONSOLE POWER ON, PRESS THE ALL CALL BUTTON KITCHEN CONSOLE 2 MAKE THE CALL ALL STATION INDICATORS STAY LIT PRESS AND HOLD THE TALK BUTTON, SPEAK TOWARDS THE CONSOLE RELEASE THE TALK BUTTON WHEN YOU ARE FINISHED TALKING NOTE: DOORBELL UNITS, AND ANY CONSOLE WITH ITS MUTE SWITCH ON, WILL NOT RECEIVE THE ALL-CALL MESSAGE KITCHEN CONSOLE 3 WAIT FOR RESPONSE
TROUBLESHOOTING SYMPTOM REMEDY POWER INDICATOR WILL NOT LIGHT EXCESSIVE HUM FROM THE SPEAKER SYSTEM FAILS TO WORK AT DISTANCE SYSTEM RECEIVES VOICE SIGNALS FROM NON-RELATED EQUIPMENT BE SURE THE CONSOLE TRANSFORMER IS PLUGGED INTO AN UN-SWITCHED OUTLET BE SURE THE DOORBELL UNIT HAS FRESH 9-VOLT ALKALINE BATTERIES KEEP CONSOLE POWER CORD AWAY FROM ANTENNA MOVE DOORBELL UNIT IF IT IS NEAR AN AC LINE BE SURE THE CONSOLE ANTENNA IS POINTED UP MOVE UNITS AROUND TO DETERMINE BETTER RECEPTION LOCATIONS CHANG
CHANGING SYSTEM SETTINGS CHANGING THE SYSTEM'S FREQUENCY IF ANOTHER INTERCOM SYSTEM IS COMMUNICATING WITH YOUR SYSTEM, TRY CHANGING YOUR SYSTEM'S FREQUENCY NOTE: ALL FREQUENCY SWITCHES MUST MATCH CHANGE THE FREQUENCY SWITCH ON EACH CONSOLE CHANGE THE FREQUENCY SWITCH ON EACH DOORBELL A CONSOLE DOORBELL CHANGING THE SYSTEM'S CODE IF, AFTER CHANGING FREQUENCY, ANOTHER INTERCOM SYSTEM IS STILL COMMUNICATING WITH YOUR SYSTEM, TRY CHANGING YOUR SYSTEM'S SECURITY CODE ON A CONSOLE: 1.
LINEAR LIMITED WARRANTY Linear Corporation (the Company) warrants to the original purchaser that products delivered hereunder will be free of defects in materials and workmanship for a period of twelve (12) months from the date of purchase.
Copyright © 2001 Linear Corporation 214601 X1 214601 X1 - IMAGE 16
