PRINTER’S INSTRUCTIONS: INSTR,INSTL,DXS-14 - LINEAR P/N: 233766 X3 - INK: BLACK - MATERIAL: 20 LB. MEAD BOND - SIZE: 5.500” X 8.500” - SCALE: 1-1 - FOLDING: ALBUM FOLD - BINDING: SADDLE-STITCH DXS-14 ALARMFORCE SUPERVISED REMOTE KEYPAD Operating Instructions AlarmForce Industries Inc.
KEYPAD OVERVIEW The LCD Supervised Remote Keypad adds remote control to Alarm Force Security System Panels. The wireless keypad transmits key presses to the panel and displays alphanumeric data received from the panel. A press of any key puts the keypad in a fully operational mode with backlit LCD and RF Transceiver active. After 15 seconds of inactivity the keypad will return to the standby mode unless tones are being generated.
REAL TIME CLOCK The keypad has a real time clock (RTC) that must be set during installation and after battery replacement. The RTC is required for the keypad to display time- and date-stamped events, using time offset data received from the panel.
Autonomous Keypad Commands and User Prompts In most operations, the keypad will only send key presses to the panel and in response the panel will update the display, LED and tone annunciations as needed to reflect the current state of the system. When doing an initial installation or manually activated program updates the keypad will function autonomously and provide user prompts without intervention by the panel.
Arming history The arming history command is serviced by the ARM DISPLAY message packet. Individual arm or disarm events are sent from the panel to the keypad in a single message packet; if arming, any bypassed zones are also included (up to 15) in the same message packet. These events are displayed one event at a time on the LCD. The user may scroll through these events and bypassed zones by pressing the keys.
Keypad Low Battery The keypad communicates a low battery condition to the panel through the low battery bit set in the KEY PRESS message.
KEYPAD WIRELESS SYSTEM The keypad has a wireless transceiver module that communicates with the microprocessor via a serial UART. The internal antenna is used for both transmit and receive functions. The transceiver module is mounted in a shielded enclosure for RFI protection. RF Transceiver Specifications The transceiver complies with FCC Part 15 and ISC Canada RSS-210 requirements. Frequency 433.92MHz ±43.4 KHz (100 ppm) Receive and Transmitt Receiver Image Rejection 30 dB L.O.
FCC / IC COMPLIANCE STATEMENT This device complies with FCC Rules and Regulations as Part 15 Rules and Regulations and Industry Canada license exempt RSS standards. Operation is subject to the following two conditions: 1.This device may not cause harmful interference and 2. This device must accept any interference received, including interference that may cause undesired operation. Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.
