Installation Instructions

PRINTER’S INSTRUCTIONS:
INSTR,INSTL,MC4140,4 CH,TX - LINEAR P/N : 215642_Rev-CX1 - INK : BLACK - MATERIAL: 20 L B. MEAD BOND - SIZE : 9.000 ” X 3.500 ” - SCALE: 1-1 - SIDE 1 OF 2
®
Multi-Code
215642_Rev-CX1 CLL lortnoC & ytiruceS ketroN 0202 © thgirypoC
USA & Canada [phone] & [phone]
[phone] - Toll Free FAX [phone]
www.nortekcontrol.com
WARNING:
the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the Federal Communications Commission (FCC) rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and
if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
MODEL 4140 FOUR CHANNEL TRANSMITTER
INSTALLATION INSTRUCTIONS
Congratulations! You have just purchased a MULTI-Code Digital Transmitter,
on the market. With a little care this transmitter should provide you with many years of excellent service. Please take a moment
to read the follo
ACCESSING THE CODE SWITCH
Insert a small coin into the slot located at the bottom end of the transmitter. Twist the coin and remove the access cover to
expose the code switch and battery compartment.
CODING
Before placing your transmitter into service, we urge you to set your codes, in order not to interfere with neighboring systems,
1). We strongly urge that several coding schemes be avoided: ALL ON; ALL OFF; 2, 4, 6, 8, 10, ON; 1, 3, 5, 7, 9, ON. These
positions are similar to our or other manufacturer’s test positions, are are frequently used.
Figure 1
CODE SWITCH
FCC & IC Notice
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et
Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux
deux conditions suivantes:
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le
fonctionnement.