Installation Instructions

PRINTER’S INSTRUCTIONS:
INSTR,INSTL,MC3089 ,1 CH,TX - LINEAR P/N: 10029379_Rev-X1 - INK: BLACK - M ATERIAL: 20 L B. MEAD BOND - SIZE : 9.000 ” X 3.500 ” - SCALE: 1-1 - SIDE 1 OF 2
®
Multi-Code
10029379_Rev-X1 CLL lortnoC & ytiruceS ketroN 0202 © thgirypoC
USA & Canada [phone] & [phone]
[phone] - Toll Free FAX [phone]
www.nortekcontrol.com
WARNING:
the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the Federal Communications Commission (FCC) rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and
if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
DIGITAL TRANSMITTER MODEL 3089
INSTALLATION INSTRUCTIONS
Congratulations! You have just purchased a MULTI-Code Digital Transmitter,
on the market. With a little care this transmitter should provide you with many years of excellent service. Please take a moment
to read the follo
ACCESSING THE CODE SWITCH
Insert a small coin into the slot located at the bottom end of the transmitter. Twist the coin and remove the access cover to
expose the code switch and battery compartment.
SELECTING A CODE
You may set your transmitter to any code you desire but be sure that the code you set matches the code that has been set on
your radio receiver. The digital code is determined by the positions of the 10 small switches numbered 1 through10 located in the
receiver and transmitter. Any combination of ON (CLOSED) or OFF (OPEN) positions can be selected by using a small screwdriver
or ball point pen. (NOTE: The switches are in the “On” position when the side next to the number is pressed in.) In setting your
own personal code we strongly urge that several coding schemes be avoided: ALL ON; ALL OFF; 2, 4, 6, 8, 10 ON; 1, 3, 5, 7, 9
ON. These positions are similar to our or other manufacturer’s test positions, or are frequently used. Once the code has been
set, check the operation and replace the hatches.