Installation Instructions

5
8
7
6
1
4
3
2
9
10
PRINTER’S INSTRUCTIONS:
INSTR,INSTL,MC3089 ,1 CH,TX - LINEAR P/N: 10029379_Rev-X1 - INK: BLACK - M ATERIAL: 20 L B. MEAD BOND - SIZE : 9.000 ” X 3.500 ” - SCALE: 1-1 - SIDE 2 OF 2
TRANSMITTER INSTALLATION
The transmitter is completely self contained, including battery, and can be operated while mounted in the car. It is supplied
with a clip for attaching to the sun visor, if desired. If the clip is used attach to the case by sliding it into the recess provided
TRANSMITTER BATTERY REPLACEMENT
Replacement battery - 9 volt NEDA 1604 (Eveready 216 or equivalent).
The battery in the transmitter can be checked or changed by removing the front lower half of the transmitter. Refer to the
directions under “accessing the code switch” for battery replacement.
TO REPLACE OR ADD A SET
A replacement or new transmitter or receiver may be purchased by specifying the Model Number and the RF frequency
digital code can be matched to the companion receiver or transmitter by following the above procedure.
FCC & IC Notice
This device complies with Part 15 of the FCC Rules and Industry Canada license exempt standard(s). Operation is subject to
the following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including interference received that may cause undesired operation.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation
est autorisée aux deux conditions suivantes:
1) l’appareil ne doit pas produire de brouillage, et
2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d’en compromettre le fonctionnement.
OPERATIONAL CHECK
To check operation, move back a reasonable distance (about 50 ft.) and press the transmitter button. Operation should be
reliable at this distance but environment and location of both the transmitter and receiver will affect the range. If the
transmitter is stowed well out of sight, it may be necessary to remove it from its mounting and hold near the windshield. Try
different locations and positions. If operation is still unsatisfactory, the problem may be isolated by:
1. Checking the door operator. If the door will not open when the wall button is pressed, the problem is likely to be the
operator. If the door will open by pressing the wall button, but not when the radio control button is pressed, the problem is
probably in the radios.
2. Replacing the transmitter battery. If after performing the above operational checks, the controls still do not function,
they should be returned to your dealer for repair or replacement.