Installation Instructions
®
Installation Instructions
Wireless Programmable
Digital Keyless Entry System
Congratulations! You have purchased the Multi-Code Wireless Programmable Digital Keyless Entry
System, which we believe to be the nest product of its type on the market. Please take a moment to
review these instructions. They will be very helpful in the proper installation and operation of your new
system.
PROCEED AS FOLLOWS:
Choose Mounting Location. Choose a convenient location that does not interfere with the normal
operation of the door, such as on the door jamb or on the wall adjacent to the door (see Figure 1). Note
that some doors will swing up, be sure that in operating your RF Programmable Keyless Entry System
you will not be in the path of the door’s travel.
IMPORTANT: Your keyless entry system should be mounted out of the reach of children.
Nortek Security & Control
5919 Sea Otter Place, Suite 100
Carlsbad, Ca. 92010
760-438-7000
BATTERY REPLACEMENT
Replacement battery - 9 volt alkaline battery.
The battery can be checked or changed by opening the battery hatch using a athead screwdriver in
the slot provided on the bottom of the keyless entry. A twisting motion of the screwdriver will open the
battery hatch and provide access to the battery compartment (Note: To avoid loss of programmed
codes while changing the battery, allow keypad LED’s to turn off before removing the old battery, and
install the new battery within 1 minute. Do not depress any key when changing battery. If the battery
is not installed within 1 minute or a key is depressed, the Wireless Programmable Keyless Entry may
reset to the factory codes. You must reprogram both radio and access codes if this happens).
FCC & IC Notice
This device complies with Part 15 of the FCC Rules and Industry Canada license exempt standard(s).
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference received that may cause
undesired operation.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts
de licence. L’exploitation est autorisée aux deux conditions suivantes:
1. l’appareil ne doit pas produire de brouillage, et
2. l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d’en compromettre le fonctionnement.
This Class B digital apparatus complies with Canadian ICES-003
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected
• Consult the dealer or an experienced radio/TV technician to help.
WARNING: Changes or modications not expressly approved by the manufacturer could void the user’s
authority to operate the equipment.
WARRANTY
All Nortek Security & Control garage door related products carry a eighteen (18) month warranty
against defects in workmanship or material. The warranty begins at the date of manufacture, for
eighteen months. Nortek Security & Control warrantee’s our product only to our authorized dealers and
distributors, and not to the end customer. If you have questions about our warranty, please ask your
dealer to determine the nature and scope of his warranty. Nortek Security & Control does not assume,
and is not responsible for, any real or consequential damages for claims against the performance of our
product, nor is it liable for any costs related to loss of life, property, or revenue. Further, Nortek Security
& Control is in no way responsible for installation of our product, and will assume no costs related to re-
installation or removal. Nortek Security & Control Warranty is in lieu of all other warrantees, expressed
or implied.
CAUTION: Any changes or modications in intentional or unintentional radiators which are not expressly
approved by Nortek Security & Control could void user’s authority to operate this equipment. This applies
to intentional and unintentional radiators certied per part 15 of the F.C.C. rules and regulations.
Copyright © 2018 Nortek Security & Control LLC 216559 C
PRINTER’S INSTRUCTIONS:
INSTR, INSTL, MCS420001, MCS298601 - P/N: 216559 C - INK: BLACK - MATERIAL: 20 LB. MEAD BOND - SIZE: 16.450” X 7.250” - SCALE: 1-1 - PRINT 2 SIDED - FOLDING: TWO FOLDS TO 7.00” x 5.5”, LOGO DISPLAYED