User's Guide

Copyright © 2018 Nortek Security & Control
28
GC2.5 Wireless Security System | User Guide
4 To conrm the user code, enter then new code again.
Tap OK.
5 A conrmation screen appears, showing that the
user code was changed. Tap OK.
Deleting a User Code
1 To delete a user code from the User Management
screen, tap the User button.
2 Tap Delete.
3 A conrmation screen appears to verify that you want
to delete the user code. If Ok, tap Delete User or tap
Cancel to return to the user codes Access Option
screen.
4 A conrmation screen appears displaying the user code
that was deleted. Tap OK.
TIP: You can change the master user code, but you cannot
delete it.
Duress User Code Setup
The Duress Code (User Code #8) initiates a silent alarm
for help by secretly sending a Duress report to the Central
Station.
Use the duress code when someone is forcing you to
operate your security system against your will. When you
use the duress code, a silent report is immediately sent to
the Central Station and they will dispatch help.
Setting the Duress User Code
1 On the User Management screen, tap the User 8
(Duress) button.
2 A conrmation screen appears: Tap Create Duress
User.
3 Enter a four (4)-digit code to use as the new duress
code. Then tap OK.
4 To conrm the duress code, enter the code again and
tap OK.
5 A conrmation screen appears. Tap OK.
6 The User 8 edit screen appears. To return to the User
Management screen, tap Back.
Secret Duress Button
On the Home screen, the system logo always appears in
the lower right corner. The system logo is the secret duress
button.
While Armed
With the system armed, tapping the logo displays the
standard disarm code entry screen. Use a valid user code
or a duress user code to disarm the system. The system
disarms normally, but a silent duress report is sent to the
Central Station and they will dispatch help. If supported
by the 2GIG Alarm dealer, the left side of this screen also
displays contact information for the alarm dealer or Central
Station.
System Toolbox