User's Guide

Copyright © 2018 Nortek Security & Control
17
GC2.5 Wireless Security System | User Guide
Disarm with a Key Fob
To disarm the system from Stay or Away mode sing a key
fob, tap the Disarm button.
NOTE: To use your key fob to disarm your system, this
option must already be enabled by your installer.
Activate the Emergency Alarm
To trigger an emergency alarm using a key fob, press
and hold the Away
button and Disarm button
simultaneously for 5 seconds.
NOTE: If an emergency alarm is, triggered by a key fob, it
cannot be stopped using the key fob Disarm button. The
alarm must be canceled at the Control Panel.
Activate the Auxiliary Output
To trigger the Control Panel’s auxiliary,output, tap the
Auxiliary button.
If you use the Auxiliary button, the auxiliary output controls
the _________________.
WIRELESS KEYPAD: ARMING AND
DISARMING
Your system may be equipped with one or more wireless
keypads. Up to four (4) wireless keypads can be used to
control the system remotely from the main Control Panel.
Two types of wireless keypads are available. A wireless
keypad without a screen, and a wireless touch screen
keypad.
The wireless touch screen keypad operates virtually the
same as the Control Panel. Each standard wireless keypad
has buttons for entering user codes, Stay and Away mode
buttons, and Fire and Police emergency buttons.
Check the See “Installer Programmed Options” on page 34,
section in this guide to verify which 24-hour Fire and Police
emergency buttons have been enabled by the installer.
Arm with a Keypad
Stay Mode
To arm the system to Stay mode using a wireless keypad:
1 At the Home screen, tap Security > Arm.
2 Enter a valid user code.
3 Tap the Stay button.
4 If Quick Arming has been programmed by your installer,
just tap the Stay button.
NOTE: If any perimeter door or window sensors are open,
the system does not allow arming to Stay mode with a
wireless keypad. All open sensors must be bypassed at the
Control Panel rst.
Away Mode
To arm the system to Away mode using a wireless keypad:
1 At the Home screen, tap Security.
2 At the Security screen, tap Arm.
3 Enter a valid user code.
4 Tap the Away button.
5 If Quick Arming has been programmed by your
installer, just tap the Away button.
NOTE: If any perimeter door or window sensors are open,
the system does not permit you to use a wireless keypad to
arm the system in Away mode. All open sensor-protected
doors and windows must either be closed or bypassed at
the Control Panel before arming with a wireless keypad.
Disarm with a Keypad
To disarm the system from Stay or Away mode, enter a
user code.
Activate a Fire Emergency
To trigger an emergency re alarm using a wireless keypad,
press and hold the Fire button for two (2) seconds.
NOTE: To use a wireless keypad to trigger a re alarm, this
option must already be enabled by your installer.
Activate a Police Emergency
To trigger an emergency police alarm using a wireless
keypad, press and hold the Police button for two (2)
seconds.
NOTE: To use a wireless keypad to trigger a police alarm,
this option must already be enabled by your installer.
Burglary Protection