User's Manual

Health, Safety and Regulatory Guide
Safety Instructions
• Read, keep, and follow these instructions. Heed all warnings.
• Clean only with a dry cloth.
• Do not install near any heat sources such as radiators, heat registers, stoves, or other
apparatus (including ampliers) that produce heat.
• Only use attachments and accessories specied by the Manufacturer.
• Read our Product Usage Guidelines at: www.SmartThings.com/Guidelines.
Safety Instructions: ADT Security Hub
Limitations of Alarm Products: This product should be tested periodically to make sure it is working
properly. The product, if used properly, may reduce the risk of burglary, robbery, and other adverse
events that have the potential to result in injury or loss of life; however, the manufacturer is not an
insurer. This product is neither insurance nor a guarantee that such an event will be prevented, and
users should protect themselves with proper insurance. The manufacturer makes no representation
that this product cannot be compromised or circumvented, that it will provide an adequate warning,
or that it will prevent any personal injuries, property damage, or other losses. Like any alarm
product, it may be bypassed, it is subject to compromise, and it may fail to warn for a variety
of reasons, including, but not limited to:
• improper installation or positioning; improper maintenance; tampering; dead or improperly
installed batteries; sensing limitations; component failures; receivers;
• intrusions may be outside of a product’s designated range and certain environmental
conditions may impact performance, and audible alarm signals may be outside of hearing
range, muted by doors, walls, and oors, unheard by deep sleepers or the hearing-impaired,
or overwhelmed by other sounds.
Risk of Noise Induced Hearing Loss: The ADT Security Hub is equipped with a warning siren.
Exposure to high sound levels or prolonged exposure to the warning siren can result in Noise
Induced Hearing Loss (NIHL).
Disclaimer
Some content and services accessible through this device belong to third parties and are protected
by copyright, patent, trademark and/or other intellectual property laws. Such content and services
are provided solely for your personal non-commercial use.
You may not use any content or services in a manner that has not been authorised by the content
owner or service provider. Without limiting the foregoing, unless expressly authorised by the
applicable content owner or service provider, you may not modify, copy, republish, upload, post,
transmit, translate, sell, create derivative works, exploit, or distribute in any manner or medium any
content or services displayed through this device.
US Certications
Certied under FCC Part 15.
ADT Security Hub
Manufacturer Model : F-ADT-HUB-1
FCC ID : EF400150
Battery Type: Shenzhen Grepow Battery CO
LTD, MFG P/N: GLP823990
ADT Door and Window Detector
Manufacturer Model : F-ADT-DW-1
FCC ID : EF400151
Battery Type: 1 x CR2450 (Panasonic)
ADT Motion Detector
Manufacturer Model : F-ADT-PIR-1
FCC ID : EF400152
Battery Type: 1 x CR123A (Panasonic)
ADT Smoke Alarm
Manufacturer Model : F-ADT-SMK-1
FCC ID : EF400153
Battery Type: 2 x CR123A (Panasonic)
ADT Carbon Monoxide Alarm
Manufacturer Model : F-ADT-CO-1
FCC ID : EF400154
Battery Type: 2 x AAA (Duracell)
ADT Keychain Remote
Manufacturer Model : F-ADT-KEY-1
FCC ID : EF400155
Battery Type: 1 x CR2450 (Panasonic)
ADT Water Leak Detector
Manufacturer Model : F-ADT-WTR-1
FCC ID : EF400156
Battery Type: CR17345 (Panasonic)
Safety Instructions: ADT Detectors
• Do not expose products to moisture or extreme temperature.
• Make sure that products are used in a dry location and within the recommended operating
temperature:
⸰ ADT Security Hub: 32° to 120° F (0° to 49° C)
⸰ ADT Door and Window Detector: 32° to 120° F (0° to 49° C)
⸰ ADT Motion Detector: 32° to 120° F (0° to 49° C).
⸰ ADT Water Leak Detector: 32° to 104° F (0° to 40° C)
⸰ ADT Smoke Alarm: 32° to 104° F (0° to 40° C)
⸰ ADT Carbon Monoxide Alarm: 32° to 120° F (0° to 49° C)
⸰ ADT Keychain Remote: 32° to 120° F (0° to 49° C)
• Make sure that the ADT Door and Window Detector is not positioned near metal or metallic
surfaces. Example: foil wallpaper.
• The ADT Water Leak Detector is water resistant but not waterproof; avoid submerging it in water
or liquid to keep interior dry and to protect batteries. All other detectors should not be used
near water or exposed to dripping or splashing of any water or liquid.
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED
BATTERIES ACCORDING TO THE INSTRUCTIONS.
Avoid installing the SmartThings Hub
near or inside sources of metal, radio
or electromagnetic interference.
WARNING: No user-serviceable parts inside. Refer all
servicing to qualied service personnel.
IMPORTANT CONSUMER INFORMATION: Please read
before activating or using the device.
WARNING: This product contains chemicals known to the State of
California to cause cancer and reproductive toxicity. For more information,
please call 1-800-SAMSUNG (726-7864).
For each of the devices listed in the previous table, the following FCC statements
and information apply:
FCC Statement
This device complies with Part 15 of the FCC rules. Operation is subject to the
following conditions: (1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
FCC Caution
Any changes or modications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this equipment.
Important Note: FCC Radiation Exposure Statement
To satisfy FCC radiation exposure safety requirements, a separation distance of 20cm or more should
be maintained between this device and a person’s body (excluding extremities: hands, wrists, feet,
and ankles.)
This ZigBee Certied Product works with
ZigBee networks supporting the Home
Automation Prole.
Global 2.4 GHz wireless use.
ZigBee® Certied is a registered trademark
of the ZigBee Alliance.