User's Manual

If the alarm emits 2 short beeps with the yellow LED

blinking twice every 48 seconds, it indicates an issue

with the alarm, which must then be replaced.

To silence the beeps and stop the yellow LED ashes,

you can press the test button and repeat as required, but

after 4 hours your alarm will no longer be supervised by

the security system.

If the alarm sounds without any apparent smoke being

present, press the test button to silence the alarm for 10

minutes. If the alarm sounds again, it may be dirty.

Pressing the test button again, within 4 minutes of the

alarm resounding, will get the alarm to re-calibrate. If

the alarm sounds again, follow the cleaning procedure

described above.

Troubleshooting

Remove the alarm from the mounting base by

twisting it counterclockwise.

The alarm regularly checks for low batteries, and will alert

you if a low battery is detected. The alarm will also beep

and the yellow LED ash to warn you the batteries must

be replaced.

Pressing the hush button will silence the beep and

the ashing yellow LED for 12 hours, if no other trouble

conditions exist.

Replacing Batteries

WARNING: Use only batteries specied. Use of different

batteries may have a detrimental effect on the smoke

alarm. Removal of the batteries will render this alarm

inoperative.