User's Manual

ManualsBrandsNortek Security & Control ManualsElectronicsZ-wave Irrigation Controller

Z-WAVE COMMAND CLASSES

COMMAND_CLASS_ZWAVEPLUS_INFO

COMMAND_CLASS_BINARY_SWITCH

COMMAND_CLASS_ASSOCIATION

COMMAND_CLASS_ASSOCIATION_GRP-INFO

COMMAND_CLASS_BASIC

COMMAND_CLASS_VERSION

COMMAND_CLASS_MANUFACTURING_SPECIFIC

COMMAND_CLASS_DEVICE_RESET_LOCALLY

COMMAND_CLASS_POWERLEVEL

COMMAND_CLASS_CONFIGURATION_V1

COMMAND_CLASS_IRRIGATION

COMMAND_CLASS_FIRMWARE_UPDATE_MD

COMMAND_CLASS_NOTIFICATION

COMMAND_CLASS_SCHEDULE

SPECIFICATIONS

Power:

120 VAC,, 60 Hz Input, 18VDC 1A Output

Signal (Frequency):

908.42 MHz/916 MHz

Range:

Up to 130 feet line of sight

Valves Supported:

Up to 15. Residential 24 VAC

Operating Temperature:

32 - 158°F (0 - 70° C

NOTICES

Z-Wave

and Z-Wave Plus

are registered trademarks of Sigma Designs and its

subsidiaries in the United States and other countries.

WARRANTY

What is Covered?

Nortek Security & Control (“NS&C”) warrants to consumers who purchase this product for

personal, family or household purposes new from NS&C directly or from an authorized

NS&C dealer, that the product will be free from defects in materials and workmanship for

a period of (1) year from the date of purchase. This warranty only applies if the product is

installed at a residence in the 50 United States or District of Columbia, and only at the site

of the original installation. It is not transferable. This warranty is not extended to resellers.

If a defect exists, NS&C will have you ship the defective part or product to us and we will,

at our option, either repair or replace it. This warranty does not cover the cost of labor to

remove a defective part or product or to reinstall any repaired or replacement part.

This warranty does not cover defects or damages caused by improper handling,

maintenance, storage, installation, removal or re-installation, misuse, non-factory

authorized modiﬁ cation or alteration, use of incompatible accessories, electrical power

problems or surges, impact by foreign objects, accident, ﬁ re, acts of God, normal wear

and tear or shipping damage other than a shipment from NS&C. Note that all NS&C

products are designed to be installed, removed and serviced by trained individuals or

professionals.

Keep your original sales receipt as it will be required to obtain warranty service.

This warranty shall not be extended or restarted upon receipt of any repaired or

replacement part or product under this warranty. No person is authorized to extend or

otherwise modify this warranty.

How do I Obtain Warranty Service?

To obtain warranty service, email our Returns Department at returns@nortek.com.

Include your name, address, telephone number, the model number of your product, a

copy of your original sales receipt, and a description of the problem. Unless we need to

discuss the situation further with you, you will be emailed a Return Authorization Number

and shipping instructions. If we need to discuss the situation further with you, we will call

or email you. NS&C may require troubleshooting on installed product before a Return

Authorization Number is issued. Anything shipped to us without a Return Authorization

Number will be automatically returned unopened. You are responsible for the charges for

shipment to us, unless you are a California resident.

Limitations

THE DURATION OF ANY IMPLIED WARRANTY, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND

FITNESS FOR A PARTICULAR PURPOSE, SHALL NOT EXCEED THE WARRANTY PERIOD PROVIDED HEREIN.

Some states do not allow limitations on how long an implied warranty lasts, so the above

limitation may not apply to you.

NS&C SHALL NOT BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE

BREACH OF ANY WRITTEN OR IMPLIED WARRANTY.

Some states do not allow the exclusion of limitation or consequential damages, so the

above limitation or exclusion may not apply to you. which vary from state to state.

This warranty gives you speciﬁ c legal rights, and you may also have other legal rights

which vary from State to State.

FCC & IC Notice

This device complies with Part 15 of the FCC Rules and Industry Canada

license exempt standard(s). Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference

received that may cause undesired operation.

Le présent appareil est conforme aux CNR d’Industrie Canada applicables

aux appareils radio exempts de licence. L’exploitation est autorisée aux deux

conditions suivantes:

(1) l’appareil ne doit pas produire de brouillage, et

(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi,

même si le brouillage est susceptible d’en compromettre le fonctionnement.

This Class B digital apparatus complies with Canadian ICES-003

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du

Canada.

This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference in a residential

installation.

This equipment generates, uses, and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions may cause

harmful interference to radio communications. However, there is no guarantee

that interference will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver

• Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected

• Consult the dealer or an experienced radio/TV technician to help.

WARNING:

Changes or modiﬁ cations not expressly approved by the manufacturer could

void the user’s authority to operate the equipment.

To satisfy FCC/IC RF exposure safety requirements, a separation distance of

20 cm or more should be maintained between this device and person’s body

(excluding extremities: hands, wrists, feet and ankles).

IMPORTANT !!!

Radio controls provide a reliable communications link and ﬁ ll an important need in

portable wireless signaling. However, there are some limitations which must be observed.

• For U.S. installations only: The radios are required to comply with FCC Rules and Regulations as

Part 15 devices. As such, they have limited transmitter power and therefore limited range.

• A receiver cannot respond to more than one transmitted signal at a time and may be blocked by

radio signals that occur on or near their operating frequencies, regardless of code settings.

• Infrequently used radio links should be tested regularly to protect against undetected interference

or fault.

• A general knowledge of radio and its vagaries should be gained prior to acting as a wholesale

distributor or dealer, and these facts should be communicated to the ultimate users.