User's Manual

ManualsBrandsNortek Security & Control LLC/2GIG ManualsElectronicsZ-Wave Module

Table Of Contents

Installing the 2GIG Z-Wave Module

10. Insert the 2GIGZ-Wave module into the STM-5 connector on the PCB

and secure with the Phillips head screw.

Figure 8 GC3 Panel—Install the Z-Wave Module

11. Replace the rear plate and secure it with two Phillips head screws.

12. Connect the internal siren/speaker connector, the Piezo Sounder

connector, and the backup battery connector to their respective PCB

connectors.

13. Install the backplate to the chassis and secure with the screw lock on the

bottom of the Control Panel.

14. Install the Cellular Radio Module, if one was present.

15. Install the hinged door.

(Optional) Lock/Unlock the Cellular Radio Module Door

The Cellular Radio Module fits into the bay on the side of the GC3 Panel and

features a built-in door lock under the faceplate. The Control Panel ships with the

door-lockscrew in the UNLOCK position. To limit the possibility of someone

removing the door, installers have the option of moving the screw to the LOCK

position.

Figure 9 GC3 Cellular Radio Module Door Lock

To lockand unlock the Cellular Radio Module door:

1. Use your fingertipsor carefully insert a screwdriver at the edge of the

faceplate. Then gentlypry the faceplate from the chassis.

Figure 10 GC3 Panel—Removeable Faceplate

2. Remove the door-lock screw from the UNLOCK position on the right.

Figure 11 GC3 Panel—UNLOCK position

3. Install the screw into the LOCK position on the left. This locks the hinged

door on the GC3 Control Panel.

Figure 12 GC3 Panel—LOCK position

4. Snap the faceplate backon the GC3 Control Panel.

FCCPart 15: Class B Digital Device Statement

for the 2GIG-ZWM-500

If the module's label is not visible when installed, then an additional permanent

label referring to the enclosed module: "ContainsTransmitter Module FCC ID:

WDQ-ZWM500" must be placed on the rear panel in a visible location.

FCC ID: WDQ-ZWM500

IC ID: 7794A-ZWM500

This device has been tested and found to comply with the limitsfor a ClassB digital

device, pursuant to Part 15 of FCC Rules. Operation is subject to the following two

conditions:

1. This device may not cause harmful interference, and

2. This device must accept interference received, including interference that

may cause undesired operation.

These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates and can radiate

2GIG® GC3 Security & Automation System

2GIG-ZWM-500 Z-Wave Module Installation Instructions

10008951A | Proprietary & Confidential