User Manual
Cushions - Seat
To remove the seat cushion, adjust the seat in a
forward position. This will make you able to see the
bracket for the gas spring.
Remove and secure the pin, then remove and
secure the bolt holding the gas spring in place. Pull
out the cushion from the gliders.
To install the seat cushion, slide the cushion on the
gliders. Position the cushion so that the bolt can
enter through the bracket and gas spring again.
Cushions - Standard Armrest
To remove the standard armrest cushion, begin by
unscrew 3 x
Screw Ø4,5 x19 A4 DIN 7983,
then pull the cushion straight out from the mold.
To install a new standard armrest cushion. Center
plugs to the corresponding holes in the mold, and
push them in. Then take the 3 x
Screw Ø4,5 x19 A4
DIN 7983,
and secure the cushion.
Number of adjustment buons may vary on chair setup and model