User Manual

CONTROL UNIT DIAGRAM
RESETTING THE ACTUATOR
RESETTING THE CONTROL UNIT
Press and hold hold together for 10 seconds.
Aerwards, control unit will beep.
The chair must be initialized aer a reset.
INITIALIZATION THE CONTROL UNIT
The initialization will run all actuators, to
dene their position. Press and hold the three
buons throughout the initialization, until all
movement has stopped. There will be a total
of six movements, that ends with the backrest
being set in a upright position.
CONNECTION DIAGRAM
There are one power input, two signal input and
seven signal output/channels.
Power Power in
IN1 Chair adjustment membrane panel
IN2 Chair memory membrane panel
WARNING:
If power cable (24V) from Control power unit is inserted in other than Power, the Control unit will
shorting.
Output/channel:
CH1 Seat height front
CH2 Seat height rear
CH3 Footrest
CH4 Backrest
CH5 Seat slide
CH6 Seat depth
IN
POWER
OUT
1 2 1 2 3 4 5 6
NORSAP 4000